SMARTGOLFGet AIX

CLUB UPDATE

SMARTGOLF club firmware update (cable)

Connect the club to a computer once with the cable. Takes about 2 minutes.

You need: Chrome or Edge on a computer (PC/Mac), the USB cable from the box (A ↔ C). Phones, Safari and C ↔ C cables won’t work.

Why update?
🔋Longer on a single chargeSaves power while idle, so the battery lasts longer.
📶Steadier connectionA stronger signal while in use fixes the occasional drops in weak-signal spots. Steadier on iPhone and iPad too.
🎯More accurate swing tempoSwing timing is recorded precisely, so tempo is more reliable.
🔄The app takes overAfter this one time, the app updates your club wirelessly.

For: clubs the app says need a cable update, and clubs received before October 2026. Serial number and calibration stay as they are.

Read the news ›

How to update

1Plug in, check the charging LED

Switch the club on and connect it to the computer.⚠ Only a USB A ↔ C cable works. C ↔ C cables won’t.
Once plugged in, the club’s charging LED must light up.

Club end with the USB cable in and the charging LED lit red
  • Charging LED: red while charging · green when full
  • Power switch: slide toward the ON or OFF label

2Start

Press Start below.

smartgolf.biz/update

Switch the club on, connect the cable, check that the charging LED lights up, then press Start.

Start update

3Pick the club

Pick CP2102N USB to UART Bridge Controller and press Connect.

smartgolf.biz/update

Switch the club on, connect the cable, check that the charging LED lights up, then press Start.

Start update
smartgolf.biz wants to connect to a serial port
CP2102N USB to UART Bridge Controller (COM5)
CancelConnect

4OFF → 10 s → ON

When asked, slide the switch off with something like tweezers, wait 10 seconds, switch it on and take your hand off. The rest is automatic.

OFF
OFF
→
10sec
→
ON
ON
→
✓Update completeAutomatic · about 1 min

Start now

Update

Troubleshooting

“This browser can’t update the club”

Open the page again in Chrome or Edge on a computer. Phones and Safari won’t work. On a phone? Copy the link and open it on a computer.

The club isn’t listed

① Check that the club’s charging LED lights up when the cable is plugged in, and that it’s the cable from the box (USB-A ↔ USB-C). C ↔ C and charge-only cables won’t work. ② Make sure the club is switched on. ③ Push the cable all the way in; thick connectors may not seat fully. ④ Try another USB port. ⑤ If it still doesn’t show, install the driver: Silicon Labs CP210x USB to UART Bridge VCP Drivers

I switched it OFF → 10 s → ON but it keeps waiting

Wait the full 10 seconds before switching on, so it powers off completely. Keep the USB cable connected. With the cable in, it’s hard to push with a finger, so gently slide the switch with something like tweezers. If the cable wiggles loose, the connection drops.

“This club can’t be updated here”

It’s a putter, a newer club or another device. Nothing was changed. Please contact support.

“Already on the app-update firmware”

Update from the app. You can still reinstall with Install again anyway.

It stopped or failed

Check the cable and power, then press Start again. Serial number and calibration are safe. Even if the club won’t turn on, writing again from this page brings it back.

Done, but the app doesn’t see the club

Switch the club off and on, then connect again.

Support

If the update doesn’t work, attach the file from Save log when you contact us.Contact us